Product
23 published CVES affecting dronecode px4 drone autopilot, from public sources (CVE.org, NVD, CISA KEV, FIRST EPSS, OSV).
Newest publication first
PX4 is an open-source autopilot stack for drones and unmanned vehicles. Versions 1.17.0-rc2 and below are vulnerable to Stack-based Buffer Overflow through the MavlinkLogHandler, and are triggered via MAVLink log request. The LogEntry.filepath buffer is 60 bytes, but the sscanf f...
PX4 autopilot is a flight control solution for drones. Prior to 1.17.0-rc1, a heap-use-after-free is detected in the MavlinkShell::available() function. The issue is caused by a race condition between the MAVLink receiver thread (which handles shell creation/destruction) and the...
PX4 autopilot is a flight control solution for drones. Prior to 1.17.0-rc2, A logic error in the PX4 Autopilot MAVLink FTP session validation uses incorrect boolean logic (&& instead of ||), allowing BurstReadFile and WriteFile operations to proceed with invalid sessions or close...
PX4 autopilot is a flight control solution for drones. Prior to 1.17.0-rc2, An unauthenticated path traversal vulnerability in the PX4 Autopilot MAVLink FTP implementation allows any MAVLink peer to read, write, create, delete, and rename arbitrary files on the flight controller...
PX4 autopilot is a flight control solution for drones. Prior to 1.17.0-rc2, the Zenoh uORB subscriber allocates a stack VLA directly from the incoming payload length without bounds. A remote Zenoh publisher can send an oversized fragmented message to force an unbounded stack allo...
PX4 autopilot is a flight control solution for drones. Prior to 1.17.0-rc2, tattu_can contains an unbounded memcpy in its multi-frame assembly loop, allowing stack memory overwrite when crafted CAN frames are processed. In deployments where tattu_can is enabled and running, a CAN...
PX4 autopilot is a flight control solution for drones. Prior to 1.17.0-rc2, The crsf_rc parser accepts an oversized variable-length known packet and copies it into a fixed 64-byte global buffer without a bounds check. In deployments where crsf_rc is enabled on a CRSF serial port,...
PX4 autopilot is a flight control solution for drones. Prior to 1.17.0-rc2, the BST telemetry probe writes a string terminator using a device-provided length without bounds. A malicious BST device can report an oversized dev_name_len, causing a stack overflow in the driver and cr...
PX4 Autopilot versions 1.12.x through 1.15.x contain a logic flaw in the mode switching mechanism. When switching from Auto mode to Manual mode while the drone is in the "ARMED" state (after landing and before the automatic disarm triggered by the COM_DISARM_LAND parameter), the...
PX4 Autopilot versions 1.12.x through 1.15.x contain a protection mechanism failure in the "Re-arm Grace Period" logic. The system incorrectly applies the in-air emergency re-arm logic to ground scenarios. If a pilot switches to Manual mode and re-arms within 5 seconds (default c...
A vulnerability was found in PX4 PX4-Autopilot up to 1.16.0. Affected by this issue is the function MavlinkLogHandler::state_listing/MavlinkLogHandler::log_entry_from_id of the file src/modules/mavlink/mavlink_log_handler.cpp. The manipulation results in stack-based buffer overfl...
Stack Buffer Overflow in PX4-Autopilot v1.14.3, which allows attackers to execute commands to exploit this vulnerability and cause the program to refuse to execute
A buffer overflow in PX4-Autopilot v1.12.3 allows attackers to cause a Denial of Service (DoS) via a crafted MavLink message.
PX4-Autopilot v1.14.3 was discovered to contain a buffer overflow via the topic_name parameter at /logger/logged_topics.cpp.
PX4 Autopilot v.1.14 allows an attacker to fly the drone into no-fly zones by breaching the geofence using flaws in the function.
An issue in PX4 Autopilot v1.14 and before allows a remote attacker to execute arbitrary code and cause a denial of service via the Breach Return Point function.
An issue in PX4 Autopilot v.1.14.0 allows an attacker to manipulate the flight path allowing for crashes of the drone via the home point location of the mission_block.cpp component.
PX4 Autopilot 1.14 and earlier, due to the lack of synchronization mechanism for loading geofence data, has a Race Condition vulnerability in the geofence.cpp and mission_feasibility_checker.cpp. This will result in the drone uploading overlapping geofences and mission routes.
A Race Condition discovered in geofence.cpp and mission_feasibility_checker.cpp in PX4 Autopilot 1.14 and earlier allows attackers to send drones on unintended missions.
PX4 autopilot is a flight control solution for drones. In affected versions a global buffer overflow vulnerability exists in the CrsfParser_TryParseCrsfPacket function in /src/drivers/rc/crsf_rc/CrsfParser.cpp:298 due to the invalid size check. A malicious user may create an RC p...
PX4-Autopilot provides PX4 flight control solution for drones. In versions 1.14.0-rc1 and prior, PX4-Autopilot has a heap buffer overflow vulnerability in the parser function due to the absence of parserbuf_index value checking. A malfunction of the sensor device can cause a heap...
Buffer Overflow vulnerability in PX4-Autopilot allows attackers to cause a denial of service via handler function handling msgid 332.
An issue discovered in Yuneec Mantis Q and PX4-Autopilot v 1.11.3 and below allow attacker to gain access to sensitive information via various nuttx commands.
Sources: CVE.org, NVD, CISA KEV, FIRST EPSS, OSV and public exploit-reference metadata. Product matching comes from the published CVE records. A proof-of-concept means public code exists; it is not evidence of exploitation.